Dd Wrt Nordvpn

Meet the NordVPN Netgear R6400 DD-WRT FlashRouter, a.k.a. The Netgear Nighthawk, a wireless networking hub with power to burn and style for miles. For 5-9 devices NordVPN Linksys WRT3200ACM AC3200 DD-WRT FlashRouter Introduced in 2002, the classic Linksys WRT54G served the role as the first Open Source DD-WRT router. Wireguard and dd wrt /nordvpn. Hi, Nord vpn have now wireguard protocol for ios and linux, I wondered if someone has set up wg with Nord on dd wrt? This thread is archived. New comments cannot.

Nordvpn

Dd Wrt Switch Config

DD-WRT WireGuard Setup Guide

Dd Wrt Nordvpn

Dd-wrt Wireguard Nordvpn

Nordvpn dd wrt router setup
The DD-WRT UI is constantly evolving and there are multiple variations depending on the specific build and version of the firmware. You may not see the exact same options in the same order as below.
This guide was produced using DD-WRT v39715.
Nord vpn flash router
  1. Navigate to the home page of your router - By default 192.168.1.1.

  2. Go to Setup > Tunnels > and click the Add Tunnel button. Choose Enable and select WireGuard from the dropdown menu.

  3. Set the MTU value of the WireGuard tunnel to 1412.

  4. Click the Generate Key button and go to the Client Area on the IVPN website to add the generated public key to the Key Management area. Make note of the IP address we assign to your public key and add it to the IP address field and enter 255.255.255.255 in the Subnet Mask field.

    Hint: After clicking Generate Key, it may or may not be possible to copy the public key displayed on the Tunnels page. Click the Save and Apply Settings buttons, then go to Administration >Commands and enter wg in the Commands box, then click Run Commands . This will display details of the WireGuard connection including the public key, which can be easily copied.
  5. Click the Add Peer button and enter the following peer configuration (as also shown in the screen shot below):

    • Peer Tunnel IP: 0.0.0.0
    • Peer Tunnel DNS: 172.16.0.1
    • Endpoint: Enable
    • Endpoint Address: Enter an IVPN WireGuard server IP address (available via the WireGuard Server List in the Client Area) and choose a port:
    • Allowed IPs: 0.0.0.0/0
    • Persistent Keepalive: 25
    • Peer Public Key: Enter an IVPN WireGuard server public key (available via the WireGuard Server List in the Client Area)
    • Use Pre-shared Key: Disable
    Note: You are welcome to use whichever server you prefer. The Endpoint Address and Peer Public Key in the example above are specific to our server in Sweden.
  6. Click the Save button, then click the Apply Settings button.

  7. In Administration > Commands, enter the following:

    Save Startup:

    Save Firewall:

    Note: The iptables commands above create a kill-switch firewall to prevent leaks. The routing table in DD-WRT is reset every time the Apply Settings button is clicked anywhere in the web interface and it takes time for the Custom Script to reapply the routing. If you prefer or do not mind leaks, please only enterin the Save Firewall area.

    Save Custom Script:

  8. In Setup > Basic Setup, you might consider setting IVPN DNS servers in the Network Address Server Settings (DHCP) area:

    • Static DNS 1: 172.16.0.1
    • Static DNS 2: 198.245.51.147
  9. Click the Save button, then click the Apply Settings button.

  10. Reboot your router and wait for a minute or two for everything to settle, then reboot your computer system.